Contact Us
Blog >> Blog Details Page

PCB Single Sided Production Process

Posted:03:28 PM May 29, 2019 writer: G

1. Cut the copper clad laminate;

Cut the copper-covered board, pay attention to the cutting specifications, and bake the board before cutting.

2. Grinding board;

The cut copper clad plate is cleaned in the grinding machine, so that the surface is free of dust, burrs and other impurities, and the first process is integrated after the grinding and baking.

3. Printed circuit;

Printed on the side of the copper, the ink has anti-corrosion effect

4. Inspection;

Remove excess ink, add ink to the place where less ink is printed. If a large number of defects are found, it needs to be adjusted. The defective product can be placed in the second step of etching to clean the ink. After cleaning and drying, it can be returned to this process for reprocessing.

5. The ink is to be dried;

6. Etching;

The excess copper skin is etched away with the reagent, and the copper skin on the circuit with the ink is retained, and then the ink on the circuit is cleaned by the reagent, and the three processes are integrated.

7. Drilling positioning holes;

The etched plate drilling locating hole

8. Grinding board;

The substrate on which the positioning hole is drilled is cleaned and dried, and is the same as the 2 substrate

9. Silk screen printing;

Silk screen printing of the insert components on the back of the substrate, some marking code, silk screen printing and drying, the two processes are integrated

10. Grinding board;

Clean again

11. Solder masking;

The green solder resist is screen printed on the cleaned substrate, green is not needed at the pad, and the ink is directly dried after printing. The two processes are integrated.

12. Forming;

Forming with a punching machine, it is possible to form the sheet twice without the need for V-pit treatment, such as a small circular plate, first from the screen printing surface to the solder mask surface into a small circular plate, and then from the solder mask surface to the silk screen surface punching hole, etc.

13. V-cut;

The small round plate does not need V-cut treatment, and the substrate is cut out by the machine into the split plate slot.

14. Rosin;

Firstly grind the board, clean the substrate dust, dry it, and then apply a thin layer of rosin on the side of the pad. The three processes are integrated.

15. FQC test;

Check if the substrate is deformed, whether the hole position and the line are good

16. Flatten;

Flatten the deformed substrate and flatten the substrate without operating the process

17. Packaging and shipping.


  • PCB
    Prototype
  • PCB
    Assembly
  • SMD
    Stencil

Dimensions: (mm)

×

Quantity: (pcs)

5
5
10
15
20
25
30
40
50
75
100
120
150
200
250
300
350
400
450
500
600
700
800
900
1000
1500
2000
2500
3000
3500
4000
4500
5000
5500
6000
6500
7000
7500
8000
9000
10000

Other Quantities:(quantity*length*width is greater than 10㎡)

OK

Layers:

Thickness:

Quote now