Film

The film consists of a protective film, an emulsion layer, a bonding film, a film base and an antihalation layer. The main components are silver salt photosensitive materials, gelatin and pigments. Under the action of light, the silver salt can be reduced to the center of the silver core, but it is not dissolved in water. Therefore, it can be suspended in a gelatin state and coated on the substrate. The emulsion also contains a pigment to sensitize. The exposed film is then obtained by actinic action.

Light painting operation--photographing system

The process is as shown below: (PCB/LCD design)-->(CAM system)-->(Gerber file)

Computer Aided Manufacturing (CAM)

Computer-aided manufacturing technology, the English name is Computer Aided Manufacturing, referred to as CAM, is an advanced technology that is controlled by computer control. The development of computer technology and the emergence of laser plotters have led to the use of PCB-assisted manufacturing technology. Various CAM systems can generally process the gerber data (Gerber data), eliminate various defects in the design, make the design easier to produce, and greatly improve the production quality.

PCB Engineering

For the production of PCB printed boards, because many designers do not understand the production process of the circuit board, the circuit diagram of the design is only the most basic circuit diagram, and can not be directly used for production. Therefore, it is necessary to modify and edit the line file before actual production. It is not only necessary to produce a film map that can be suitable for the production process of the factory, but also to make corresponding punching data, mold opening data, and other data useful for production. It is directly related to various production projects in the future. These require engineers and technicians to understand the necessary production processes, and at the same time master the relevant software production, including common circuit design software such as: Protel, Pads2000, Autocad, etc., should be familiar with the necessary CAM software such as: View2001, CAM350; GCCAM Etc., CAM should include PCB design inputs, which can edit, correct, repair, and imprint circuit graphics, use disk as the dielectric material, and output automated data for ray mapping, drilling, and inspection.

PCB Manufacturing Process

With the development of the electronics industry, the requirements for printed boards are getting higher and higher. The high density of the printed board design, the thin wire, the small aperture tend to be faster and faster, and the production process of the printed board is more and more perfect.